Cabinet fillers, panels and moldings people forget to order
By the CabinetDeals design team ยท Updated

Cabinet boxes are only part of the order. Every cabinet side that shows needs a finished end or a panel. Gaps at walls and appliances need fillers or scribe. Base cabinets need a toe kick cover, wall cabinets usually get crown on top and light rail underneath, and the floor line may want quarter round or base molding. In Fabuwood's Allure line each of these is a separate item or an option you choose when you order, so if it isn't on your item list, it won't be on the truck.
Below, piece by piece, with the usual mistake for each. The Fabuwood details come from the Allure spec book (2026-01-08). Other Fabuwood lines can differ, so check yours.
Finished ends, skins and decorative panels
Any cabinet side you can see needs a finished surface. In Allure the plain cabinet sides are unfinished plywood, so an exposed side gets one of three things:
- Finished end. When you order, you mark which sides are exposed: left, right or both. Fabuwood applies a 1/4 inch panel to that side and finishes it close to flush.
- Skin. A loose 1/4 inch finished panel cut to cabinet sizes (base, wall, tall, microwave), put on during install.
- Thicker and decorative panels. A 3/4 inch base end panel, refrigerator end panels 3/4, 1 1/2 or 3 inches thick (up to 120 inches tall for a 30 inch deep panel), and a dishwasher return panel. For a door look, a wainscot panel has the same profile as the cabinet door, and deco doors come in standard door sizes.
You need one at the end of every run, on the back and sides of an island or peninsula, beside a fridge at the end of the cabinets, and on the open side of a dishwasher at the end of a run.
The two that get missed: the island back and the fridge side. The other slip is ordering a flat skin where you pictured a panel that looks like a door. A fridge end panel and a wainscot panel are different pieces with a different look, so pick the one you want before you order.
Fillers and scribe
A filler is a strip between a cabinet and a wall, an appliance or another cabinet. It does two jobs: it gives doors and drawers room to open without hitting the wall or a handle, and it takes up the inches when cabinet widths don't add up to the wall. Allure makes wall, tall and base fillers 3 and 6 inches wide, plus overlay fillers.
Scribe is a thin molding cut to follow a wall that isn't straight. Allure lists a simple and a decorative scribe in 8 foot lengths.
Plan on a filler next to most walls, in corners, and beside tall cabinets and appliances. Some pull-outs need them too: Allure's spice pull-out and towel bar pull-out each need a filler and an overlay filler, ordered separately. Our guide to kitchen pull-outs covers those.
Where it goes wrong: cabinets planned wall to wall with no filler. It fits on paper, and then on install day a door hits the wall or a drawer can't clear the handle next to it.
Toe kick
The toe kick is the recessed strip at the bottom of base and tall cabinets, where your toes go. Allure cabinets arrive with a 3/4 by 4 1/2 inch unfinished plywood toe kick attached. The finished cover that matches your door style is a separate item, sold in 8 foot lengths, 1/4 inch thick or in a 3/4 inch version. Where the end of a toe kick shows, a toe kick cap finishes it to match the finished side. It is cut on site.
Don't assume the cover comes on the box. It doesn't. Count the length of every base run, every tall cabinet and every island side you can see.
Want a designer to plan it with you?
A free call, a first layout and a review together. You see an initial 3D design and a cabinet price before you pay anything.
Get your free kitchen designCrown molding
Crown is the trim along the top of the wall cabinets, and most kitchens with uppers get it. It closes or dresses up the gap between the cabinets and the ceiling. Allure has several profiles in 8 foot lengths, from a small cove to an extra-large cove crown, plus a shaker crown in Dove, Kona and Indigo only. Stacking and extension moldings are listed too, for building the trim taller.
Two things trip people up:
- The starter molding. Fabuwood says crown should go on with its starter molding or similar bracing. If you order the crown, order the starter, or check that your installer has bracing of their own.
- Exact lengths. Crown is cut at every corner, so a run that measures 8 feet can take more than one 8 foot piece. Measure the gap above the cabinets at a few points too, because ceilings are rarely level.
Light rail molding
Light rail runs along the bottom of the wall cabinets. It hides under-cabinet lights from someone sitting at the table and gives the underside a finished edge. Allure's light rail comes in 8 foot lengths, with a profile that changes by door style family (Nexus; Luna, Galaxy and Onyx; Fusion).
If you're adding under-cabinet lighting, add the light rail with it. Leave it off and you find out at dinner that you can see every light strip.
Quarter round, shoe and base molding
Where the cabinets meet the floor, a small trim hides the gap an uneven floor leaves. Quarter round is a quarter circle, shoe molding is a taller, thinner version, and base molding is a flat board like the baseboard on your walls. Allure lists a 3/4 inch quarter round, a 5 1/2 inch base board molding and inside and outside corner moldings, all in 8 foot lengths.
Use it along toe kicks and cabinet ends where the floor isn't flat, or where you want the cabinets to match the room's baseboard. Some installers bring their own trim, so ask yours.
Ask "is quarter round included?" before the order goes in, not after. It's a separate item, so it's on your list only if someone put it there.
Before you order: a quick check
Go down your item list and look for:
- a finished end or panel on every side you can see, island back included
- fillers at walls, corners, tall cabinets and appliances
- toe kick cover for every base run, tall cabinet and visible island side
- crown, with starter molding, if you want trim at the top
- light rail, if you have under-cabinet lights
- quarter round or base molding, unless your installer brings their own
How a designer helps
Our designers answer questions about panels, fillers and moldings often, especially which panel goes on an exposed side.
Another one they explain often: a homeowner prices a cart on their own, then a designer's quote comes in higher. When we go through why, the difference is often the pieces on this page, the moldings, panels, fridge panels and accessories the cart never had. A total that leaves them out looks cheaper, but those pieces still have to be bought before the kitchen is finished.
If you work with a designer, the free review is where this gets settled. Your designer goes over the whole plan with you, item by item, and that's where the panels, fillers and trim get named. Nothing is made until you approve the layout and the item list and your measurements are confirmed. And before a designer order goes to Fabuwood, we check it for errors, sizes and fillers included.
Questions buyers ask
Do Fabuwood cabinets come with finished sides? In Allure, you choose the exposed sides when you order (left, right or both) and Fabuwood applies a 1/4 inch finished panel to them. Sides you don't mark stay unfinished plywood.
Is quarter round included with the cabinets? No. In Allure it is a separate item, sold in 8 foot lengths, like the other moldings.
What fills the gap above my cabinets? Usually crown molding, sometimes built taller with stacking or extension molding. Taller wall cabinets are the other answer. Your designer can show both in the 3D design.
Can panels and fillers be cut to fit? Yes. Fillers, panels and moldings are usually trimmed on site. Fabuwood can also cut a panel to size before it ships, but a cut edge doesn't come edge banded.
Will my designer's price include these pieces? Ask your designer to show you each one in the review. They go over the plan item by item and give you the price at the end, so you can see what it covers before you decide.
Your next step
Get a free design and cabinet price from a designer. In the review we go through your plan item by item, panels, fillers and trim included, so you can see them on the plan before you approve anything.
Already know your layout? Browse the Fabuwood door styles.
Related: How our free kitchen design works.